Table of Contents
Advertisement
Installing the Software
1.
Power up the Emblaser 2
Press the Power button on the front left corner of your
Emblaser 2.
After a few seconds, a new drive will appear on your
computer called 'Emblaser2'. This is the internal storage on
your Emblaser 2.
2.
Install the software drivers
If you are using a computer running Windows 10 (or later)
or OSX, you do not need to install any software drivers.
For other operating systems, install the driver located on
the Emblaser 2 internal storage. Check the Help Centre at
the following link for step-by-step instructions:
http://tinyurl.com/e2start
3.
Install Laserweb Software
Laserweb is used for controlling your Emblaser 2. The
latest version can be downloaded from the 'Getting Started'
section of our 'Help Centre'.
http://tinyurl.com/e2start
4.
Apply Emblaser 2 profile
Run Laserweb and select 'Settings' tab on the left. In the
'Machine Profiles' tab, use the drop down list to select
'Emblaser2' and then press the 'Apply' button.
This will configure Laserweb to work with the Emblaser 2.
16
Advertisement
Table of Contents
