Replacing the Diode Module
26
1.
Jog the laser unit up
Before you begin any replacement steps, ensure the laser
unit is at its highest position. Use Laserweb to jog the laser
unit to this position.
NEVER force the laser unit to move by hand.
Always use Laserweb to adjust its height.
2.
Remove fan
Use the provided hex wrench to remove the four (4) screws
holding the fan in place.
3.
Remove old diode module
Place a flat-head screwdriver into the groove located under
the diode module electronics PCB. Gently lever the diode
module up and out of the heat-sink.
The old diode module will be coated in a thermal paste.
Avoid touching the paste and wash your hands thoroughly
if it contacts your skin.
Do not remove any thermal paste from within the heat-
sink.