Table of Contents
Advertisement
5. USING YOUR EMBLASER 2
'Enabling' the Laser
Before your Emblaser 2 will allow the laser to emit laser light, it must be manually 'enabled'.
This is achieved by pressing the 'Enable' button on the front right corner of the Emblaser 2.
The 'Enable' button will light up 'red' when successfully enabled.
Action
Upon Power Up
Lid Closed + Enable
Lid Open when Enabled
Lid Open + Enable
It is recommended that you 'enable' the laser only when ready to cut or engrave.
18
When the Emblaser 2 is turned on the laser is kept in a safe
mode. This is indicated by the 'enable' button not lit.
With the lid closed, the laser can be enabled by pressing the
'Enable' button. This is indicated by the 'enable' button being
lit.
The laser will immediately become 'disabled' when the lid is
opened. This is indicated by the enable button light turning off.
The laser will not 'enable' if the lid is open.
It's a good habit to 'disable' the laser at all other times.
Result
Advertisement
Table of Contents
