Table of Contents
Advertisement
Health Warning Information (cont.)
Always follow your local Occupational Health and Safety (OH&S) rules
Ensure that you comply with local occupational health and safety legislation. Failing to do so
could put you in breach of the law. Even if not being used in a business, owners may be in
breach of the law if injuries occur, since injury to a member of the general public could con-
ceivably constitute a breach of the owner's OH&S obligation under law, subject to penalties.
Visit your local government website for OH&S information on laser safety requirements.
Those operating the Emblaser within an established business should nominate a designated
laser safety officer, responsible for the safe use, training, and upkeep of the Emblaser and
associated personal protective equipment, administrative controls such as user credentialing
and safe operating procedures (SOPs), and engineering controls, such as ventilation
Fire
A laser cutter / engraver works by amplifying light to such a degree as to either melt or burn
material while following a designated path. The heat generated during this process could po-
tentially cause combustion (fire) within the material being worked on.
Ideally, a smoke / fire detector should be installed in the area the Emblaser 2 is being used.
A fire blanket and smoke extinguisher should always be readily accessible.
Technical support
Servicing the Emblaser 2 and Accessories
The Emblaser 2 is designed to require minimal service. Please refer to the 'Caring for your
Emblaser 2' section of this manual for maintenance information.
For any problems that arise not covered in this section, please contact your reseller.
Darkly Labs
130 Melrose Drive, Tullamarine, 3043 Australia
info@darklylabs.com ● www.darklylabs.com
R
Copyright © Darkly Digital Pty Ltd (Darkly Labs) 2014-2017.
33
Advertisement
Table of Contents
