Introduction; What's In The Box - Darkly Labs EMBLASER 2 User Manual

3. INTRODUCTION

What's in the box

Emblaser 2
Fully assembled Emblaser 2.
USB A-B Cable
USB cable for connecting the
Emblaser 2 to a computer.
Cutting Mats
Four (4) cutting mats.
GETTING STARTED
Congratulations on receiving your new Emblaser 2
To help get you started, visit our online Help Centre for the user manual, software and more information:
tinyurl.com/e2start
Always use your Emblaser 2 safely and never leave it operating unattended.
SAFETY CHECKLIST WARNING!
FIRE IS A REAL THREAT
Have you checked to ensure your material is
safe to use from fumes, vapors or fire hazards? Keep a fire blanket and fire extinguisher
handy. Install a smoke alarm above the
Do you have adequate ventilation? laser cutter.
Have you measured and set the material
DO NOT leave laser cutter unattended
height?
when in operation.
If using the indoor filtration unit, is it turned
on?
DO NOT use materials that are highly
Have you checked the filtration filters recently? flammable, explosive or produce toxic
by-products.
Have all users been trained on the potential
hazards, control procedures for operating the
NEVER use these materials:
laser cutter?
PVC, Vinyl, Polycarbonate/lexan, ABS,
Is the Laser 'enabled'? HDPE, PolyStyrene Foam, Fiberglass or
Carbon Fiber.
WARNING: Always ensure adult
supervision when children are present.
01
SUPPORT
02
04
If you encounter any issues, have any questions, feature requests, or feedback for our
support team, please contact your local reseller or contact support below.
support@3dprintingsystems.com
Software, forum & updates
https://darklylabs.zendesk.com
1. Laser.
03
2. Power Button.
3. Enable Button.
4. Lid
Info / Safety Card
Instructions to getting started.
Power Adaptor
110-240v power adaptor.
Tool / Cleaning Kit
Various tools and cleaning
supplies.
Darkly Labs
R
Tube for venting fumes.
Country specific power lead.
Exhaust Tube
Power Lead
10