Making Frothed Milk - BRAYER BR1115 Instruction Manual

14 EN
Notes: you can adjust the milk foam supply intensity when
making latte.
• Insert the power plug into the mains socket.
• Switch the coffee maker on by setting the power switch
(11) «0/I» to the position «I», the indicator (7, 8, 9) will
light up and start flashing.
• When the coffee maker is ready for operation, the light
indicator (7, 8, 9) will glow constantly.
• To make one cup of latte use a small filter (21) and
press the «Latte»-button (9) once; the light indicator «
» will light up.
• To make two cups of latte use a big filter (20) and press
the «Latte»-button (9) twice; the light indicator «
light up.
Note: if you need to switch the coffee maker off during the
latte making, press the «Latte»-button (9) again.
• Remove the cup with the ready drink from the grid (2).
• After you finish using the coffee maker, switch the
coffee maker off by setting the switch (11) «0/I» to the
position «0».
• Wait until the coffee maker cools down, remove the
filter holder (20) and wash the filter (21 or 22).
• If there is some milk left in the cappuccinator, remove it
and put the cappuccinator into the fridge (pic. 12), if you
used all milk during making coffee, it is recommended
to remove the cappuccinator and clean it (see the
chapter «CAPPUCCINATOR CLEANING»).

MAKING FROTHED MILK

• You can make necessary amount of frothed milk anytime.
• You can use the frothed milk for making hot chocolate,
macchiato, masala tea etc.
• It is important that milk for making frothed milk is fresh and
cold and without additives.
• Take usual whole milk with fat status from 4% to 6%,
cream fat status is not less than 10%.
• Prepare the coffee maker as described in the chapters
above, but do not add ground coffee into the filters (21 or
22).
• Place a cup of suitable height and capacity on the grid (2).
• Direct the cappuccinator pipe (15) into the cup using
» will
the cappuccinator pipe angle adjustment bar (14), if
necessary, change the length of the cappuccinator pipe
(15) (fig. 9).
• Turn the frothed milk supply (intensity) control knob (17)
to the right (in this position it produces more frothed milk)
(pic. 11).
Notes: you can adjust the milk foam supply intensity when
making.
• Switch the coffee maker on by setting the power switch
(11) «0/I» to the position «I», the indicator (7, 8, 9) will light
up and start flashing.
• When the coffee maker is ready for operation, the light
indicator (7, 8, 9) will glow constantly.
• Press and hold the «Cappuccino»-button (8) for 3
seconds, the indicators « » and « » will light up.