Making Coffee - BRAYER BR1124 Instruction Manual

8 EN
SETTING CURRENT TIME
• Plug the power cord into an electrical outlet and the
flashing digital symbols (13) «12:00» will be displayed.
• To set the current time in «hours», press the button
(24) « », the setting range is from 0 to 23 hours,
the setting step is 1 hour. To quickly scroll through the
«hours» setting time, press and hold the button (24) «
».
• To set the current time in «minutes», press the button
(23) « », the setting range is from 00 to 59 minutes,
the setting step is 1 minute. To quickly scroll through
the «minutes» setting time, press and hold the button
(23) « ».
• In the current time mode the separating dots «:» flash.

MAKING COFFEE

• Ready coffee is made by single passing of hot water
through the layer of ground coffee in the filter (7).
The taste of the drink depends on the quality of raw
products, therefore we recommend using well-roasted
and fresh-ground coffee beans.
• Remove the Cover (8).
• • Install the filter (7) in the filter holder (6).
• Measure the required amount of ground coffee and put
it into the filter (7). 6 grams of ground coffee per one
coffee cup is required on average; adjust the quantity
according to your taste.
• Fill the tank (9) with cold water up to the required level.
Determine the water level using the scale (10).
• Close the lid (8).
• Put the flask (2) on the tray (1).
• Plug the power cord into an electrical outlet and the
flashing digital symbols (13) «12:00» will be displayed.
Note: if you need to set the current time, refer to the Setting
Current Time section.
• Press the on/off button (21) « », the indicator (17) will
light up, the coffee maker will switch on and coffee will
flow into the flask (2).
• Wait for the water to completely drain and then switch
the coffee maker off by pressing the coffee maker on/
off button (21) « » again, the indicator (17) goes out,
unplug the power cord from the electrical outlet.
• If necessary, you can switch the coffee maker off at any
time by pressing the button (21) « ».
• While preparing coffee, you can remove the flask (2)
from the tray (1) for a short time (no more than 30
seconds), pour the prepared coffee into cups and put the
flask (2) back on the tray (1).
• To keep the coffee hot, leave the flask (2) on the tray (1)
and do not switch the coffee maker off.
Notes: the keep warm time for ready coffee is limited to 40
minutes, after that the coffee maker will switch off.
ATTENTION!
• When it is no longer necessary to heat the flask (2),
switch the coffee maker off by pressing the coffee maker
on/off button (21) « ».