Before Using The Unit - BRAYER BR1115 Instruction Manual

8 EN
• Unpack the coffee maker and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the coffee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the lower panel of the unit
correspond to the specifications of your mains. When
the unit is used in the mains with 60 Hz frequency, it
does not need any additional settings.
• Wipe the surface of the coffee maker body with a clean,
slightly damp cloth to remove dust.
• Before using the coffee maker for the first time, wash
all removable parts (1, 2, 12, 13, 16, 18, 20, 21, 22, 23)
with warm water and neutral detergent and dry them.

BEFORE USING THE UNIT

ATTENTION! If you switch the coffee maker on and
don't perform any actions, the coffee maker will
switch off in 15 minutes. To switch the coffee maker
on press any button (7, 8, 9).
• Place the coffee maker on a steady flat heat-resistant
surface, the distance from the side walls of the coffee
maker should be at least 20 cm, and the gap above the
coffee maker should be at least 30 cm.
• Do not use the coffee maker under kitchen shelves of
cupboards. They can be damaged by the steam released
during the coffee maker operation.
• The coffee maker should be placed out of reach of small
children.
Attention! Before making coffee for the first time it is
recommended to wash the broiler, the cappuccinator lid (16)
and the milk container (18).
• Make sure that the removable tray (1) and the tray grid
(2) are installed to their places.
• Remove the lid (12), remove the water tank (13).
• Fill the tank (10) with cold water up to the maximal level
mark, install the tank (13) back to its place.
Note: the tank (13) is intended for water only, do not fill the
tank (10) with other liquids, such as milk.
• Take the container (18), pull it towards yourself and
remove it, remove the cappuccinator from the container
(18) (pic. 1). Fill the container with water up to the
maximal level mark.
Note: the cappuccinator container (18) is intended for milk
only, do not fill the container (18) with other liquids, use
water only in the cappuccinator lid (16) washing mode.
• Install the cappuccinator lid (16) on the container (18)
and install the cappuccinator back to its place until the
lock clicking.
Notes: after installing the container (18) with the lid (16)
back to its place always check if the cappuccinator is
installed and fixed properly.