BRAYER BR1115 Instruction Manual page 15

• After making the necessary amount of frothed milk stop
the process by pressing the «Cappuccino»-button (8)
again.
• Remove the cup with frothed milk and use the frothed
milk for the intended purpose.
• After you finish using the coffee maker, switch the
coffee maker off by setting the switch (11) «0/I» to the
position «0».
• If there is some milk left in the cappuccinator, remove it
and put the cappuccinator into the fridge (pic. 12), if you
used all milk during making coffee, it is recommended
to remove the cappuccinator and clean it (see the
chapter «CAPPUCCINATOR CLEANING»).
CAPPUCCINATOR CLEANING
• We recommend cleaning the cappuccinator after the
milk container (18) is empty.
• Take the container (18) and remove it (pic. 1), remove
the cappuccinator lid (16) from the container (18).
• Wash the container (18) with a neutral detergent,
remove the milk intake pipe from the cappuccinator lid
(16) and wash it, rinse all the parts, dry them and install
the milk intake pipe back to its place.
• Turn the steam nozzle counterclockwise and remove
it from the cappuccinator (16) body (pic. 11), wash the
nozzle.
• Remove the cappuccinator pipe (15) by turning the
pipe (15) counterclockwise, rinse the pipe (15), install it
back to its place, fix the pipe (15) by turning it clockwise
(fig. 9).
• Grasp the left side and raise the silicone plug (pic. 14),
rinse the cappuccinator lid (16) under a warm water jet,
close the silicone plug.
• Install the steam nozzle back to its place and turn it
clockwise (pic. 15).
• Prepare the coffee maker as described in the chapters
above, but do not add ground coffee into the filter (21 or
22).
• Place a cup of suitable height and capacity on the grid
(2).
• Fill the container (18) with water, do not exceed the
maximal level mark.
• Install the cappuccinator lid (16) on the container (18)
and install the cappuccinator back to its place until the
lock clicking.
• Direct the cappuccinator pipe (15) into the cup using
the cappuccinator pipe angle adjustment bar (14), if
necessary, change the length of the cappuccinator pipe
(15) (fig. 9).
• Turn the frothed milk supply (intensity) control knob (175)
to the right to the position «
• Switch the coffee maker on by setting the power switch
(11) «0/I» to the position «I», the indicator (7, 8, 9) will
light up and start flashing.
• When the coffee maker is ready for operation, the light
indicator (7, 8, 9) will glow constantly.
• Press and hold the «Latte»-button (9) for 3 seconds, the
indicators « » and « » will light up.
EN 15
».