Making Espresso - BRAYER BR1113 Instruction Manual

• Wait until the button (15) indicator stops flashing and
glows constantly, then switch the water supply on by
pressing the button (15) «
press the button (15) «
supply off, drain water from a cup.
• Preheating is over.

MAKING ESPRESSO

ATTENTION! When making coffee do not leave the
operating coffee maker unattended, as it is necessary to
watch the cup being filled with ready coffee!
AFTER PREHEATING:
• Make sure that the steam supply is closed. To do this
turn the knob (8) « » clockwise until bumping
«●».
• Remove the filter holder (5) by turning the handle (3)
to the left «Insert» and remove the filter holder (5).
• Put ground coffee in the filter (5), slightly tamp the
ground coffee with the back side of the measuring
spoon (17).
• Install the filter holder (4) into the coffee maker. The
holder (4) ledges should match the grooves on the
boiler «Insert», after that turn the filter holder handle
(3) to the right until bumping «Lock».
• Wait until the indicator (11) lights up, the coffee
maker is ready for making coffee.
• Switch the water supply on by pressing the button
(15) « », watch the cup filling with the ready
», after 15-20 seconds,
» again to switch the water
coffee, press the button (15) «
water supply off.
Notes:
- when you press the button (15) «
will switch on for 3 seconds to pre-wet the ground
coffee in the filter (5), after a three-second pause,
the pump will switch on and will work until it is
switched off by pressing the button (15) «
again;
- the pump operation time is limited to 60 seconds,
if during this time the cup is not filled with ready
coffee, switch the water supply on again by
pressing the button (15) «
• Switch the coffee maker off by pressing the on/off
button (14) « », the button (16) indicator will
go out.
• Wait until the coffee maker cools down and remove
the filter holder (5) by turning the handle (4) to the left
«Inser». Remove the ground coffee remnants and
wash the filter (6).
• For easy removing of the coffee remnants use the
retainer on the handle (3) to prevent the filter (5) from
falling off the holder (4).
Notes:
- the cups should be preliminary heated up, when
water heats up in the boiler, put the cups on the
tray (7).
EN 9
» again to switch the
», the pump
»
».