BRAYER BR1115 Instruction Manual page 9

• Set the milk supply intensity control knob (17) to the
middle position.
• Install one of the coffee filters (21 or 22) into the filter
holder (20) matching the ledge on the filter (21 or 22)
with the hole on the holder (20) and turn the filter (21
or 22) counter/clockwise. Do not add ground coffee
into the filter (21 or 22) when preparing the coffee
maker for work.
• Install the filter holder (20) into the installation place «
» and turn the handle (4) to the right as far as it will
go « » (pic. 2, 3, 4).
• Place a cup of suitable height and capacity of at least
300 ml on the tray grid (2).
• Direct the cappuccinator pipe (15) into the cup using
the cappuccinator pipe angle adjustment bar (14).
Note: You can change the length of the cappuccinator
pipe (15) by turning the pipe (15) counterclockwise, then
extend it to the required length, and fix the pipe (15) by
turning it clockwise (fig. 9).
• Insert the power plug into the mains socket.
• Switch the coffee maker on by setting the power switch
(11) «0/I» to the position «I», the indicator (7, 8, 9) will
light up and start flashing.
• When the coffee maker is ready for operation, the
indicator (7, 8, 9) will glow constantly.
• To switch the cleaning mode on press the
«Cappuccino»-button (8) twice. After cleaning is
finished, all the light indicators of the control buttons
(7, 8, 9) will light up.
• After you finish cleaning the coffee maker, switch the
coffee maker off by setting the switch (11) «0/I» to the
position «0».
• Pour the water out of the cup, take the container (18),
pull it towards yourself and remove (pic. 1), remove the
cappuccinator lid (16) from the container (18), pour the
remaining water from the container (18). Slightly lift the
front part of the tray (1) and remove it, pour the water
out of it and install the tray (1) back to its place.
• Turn the filter holder handle (4) to the left and remove it
(pic. 2, 3, 4). Wait until the filter holder (20) cools down
completely and remove the installed filter (21 or 22)
turning it counter/clockwise. Wash the filter (21 or 22)
and install it into the filter holder (20).
• If necessary, clean the boiler and the cappuccinator lid
(16) several times.
• After cleaning the coffee maker is ready for operation.
CHOOSING THE APPROPRIATE CUP
• Before making coffee, please, select a cup of
appropriate capacity according to the table:
Drink
Espresso: оne / double
Cappuccino: оne / double
Latte: one / double
EN 9
Estimated amount of the ready
drink
90 ml/130 ml
150 ml/270 ml
280 ml/400 ml