Table of Contents
Advertisement
Figure 188. LCD panel features
Table 66. LCD panel features
Item Button or
display
1
Left
2
Select
3
Right
4
LCD display
Viewing Home screen
The Home screen displays user-configurable information about the system. This screen is displayed during normal system
operation when there are no status messages or errors. When the system turns off and there are no errors, LCD enters the
standby mode after five minutes of inactivity. Press any button on the LCD to turn it on.
Steps
1. To view the Home screen, press one of the three navigation buttons (Select, Left, or Right).
2. To navigate to the Home screen from another menu, complete the following steps:
a. Press and hold the navigation button till the up arrow
b. Navigate to the Home icon
c. Select the Home icon.
d. On the Home screen, press Select to enter the main menu.
Setup menu
When you select an option in the Setup menu, you must confirm the option before proceeding to the next action.
Table 67. Setup menu
Option
Description
iDRAC
Select DHCP or Static IP to configure the network mode. If Static IP is selected, the available fields
are IP, Subnet (Sub), and Gateway (Gtw). Select Setup DNS to enable DNS and to view domain
addresses. Two separate DNS entries are available.
Set error
Select SEL to view LCD error messages in a format that matches the IPMI description in the SEL.
Matching the format enables you to match an LCD message with an SEL entry. Select Simple to view
LCD error messages in a simplified description. For information about the event and error messages that
are generated by the system firmware and agents that monitor system components, go to qrl.dell.com. Go
to Look Up > Error Code, type the error code, and then click Look it up.
Description
Moves the cursor back in one-step increments.
Selects cursor-highlighted menu item.
Moves the cursor forward in one-step increments.
During message scrolling:
● Press and hold the right button to increase scrolling speed.
● Release the button to stop.
The display stops scrolling when the button is released. After 45 s of inactivity, the display starts
scrolling.
Displays the system information, status, and error messages or iDRAC IP address.
using the up arrow
is displayed.
.
System diagnostics and indicator codes
197
Advertisement
Table of Contents
