Table of Contents
Advertisement
Figure 89. Lift up the TIM break lever
NOTE:
Ensure to return the TIM break lever back to original position.
4. Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the
retaining clip release tab, and then lift the retaining clip partially from the DLC module.
5. Repeat the procedure at the remaining three corners of the retaining clip.
6. After all the corners are released from the DLC module, lift the retaining clip from the pin 1 corner of the DLC module.
Figure 90. Removing the retaining clip
110
Installing and removing system components
Advertisement
Table of Contents
