Pentair E-Box MAESTRO Lite Installation And Operation Manual page 67

Change of units & voluntary correction of values
Info
All these values remain stored when changing batteries.
This mode allows you to modify the units of:
• air temperature & water temperature (factory pre-set in °C);
• the height of the water (factory pre-adjusted in cm);
• conductivity (factory pre-set in μS).
This mode is used to correct the measured values of:
• the air temperature;
• the water temperature.
1. Place the switch in alarm mode (rear side of the Inner Display).
ð Calibration mode is selected on the Inner Display:
Air & Water Temperature Unit (°C/°F)
1. Press to select the air & water temperature unit
2. Use to change the unit.
3. Press to confirm the selection.
Ref. SB-CU-IMP-062EBLA / A - 11.05.2023
Installation and Operation Guide Version E-Box MAESTRO Lite - Programming
calib
alarm
on
.
67 / 90