Jungheinrich DFG 435 Operating Instructions Manual page 133

Impact sensor
Electrical System
Check impact sensor is secure and check for damage.
Sideshifter
Hydraulic operations
Check attachment is properly secured to the truck and the
supporting elements.
Test hose reel and check for leaks and damage.
Attachment:
check bearing points, guides and stops for wear and damage,
grease and clean these components.
Check cylinder piston rods and bushings.
Test sideshifter, check settings and check for damage.
Test operation and setting of the attachment.
Check attachment for damage.
Check cylinder seals.
Check sliding blocks are complete.
Check axial play of the front and rear rollers and adjust if necessary.
Check hydraulic ports and tighten if necessary.
Attachment:
Clean and lubricate.
Seat heating
Electrical System
Check electric wiring for damage [insulation damage, connections].
Make sure wire connections are secure.
Road traffic approval (StVZO)
Electrical System
Test lighting.
Telescopic forks
Hydraulic operations
Attachment:
Clean and lubricate.
Check hydraulic ports and tighten if necessary.
Check cylinder seals.
W A B C
t
W A B C
t
t
t
t
t
t
t
t
t
t
t
W A B C
t
W A B C
t
W A B C
t
t
t
133