Schwinn Journey 1.0 Service Manual page 39

5. Remove the T-handle and washers that attach the Handlebar
to the Mast. Set them safely aside for reassembly.
NOTICE: Hold the Handlebar so that it does not fall.
6. Remove the Handlebar and set it safely aside for reassembly.
7. Bend the edges of the Top Shroud to disengage the inside tabs
from the Main Assembly, and slide the Mast Gasket and Top Shroud
up the Mast.
8. Remove the hardware (indicated) from the Mast. Gently pull
the Mast out and disconnect the cables. Set the hardware, Mast
Gasket and Top Shroud safely aside for reassembly. Discard the old
Mast.
NOTICE: Do not crimp the cables. This step may require two
people.
Note: Do not let the cables fall down inside the Frame.
9. Install the replacement Console Mast, and the Mast Gasket
and Top Shroud on Main Assembly.
NOTICE: Make sure the Console Cable connector does not
fall into the Console Mast. Align the clips on the
cable connectors and make sure the connectors
lock. Do not crimp Console Cable. Be sure the tabs
on the Top Shroud snap into the Main Assembly.
39
X2