Schwinn Journey 1.0 Service Manual page 33

12. Using a #2 Phillips Screwdriver, remove the 4 screws that
secure the Right Shroud. Remove the bottom screws first. and then
the top screws. Slowly remove the Right Shroud.
13. Installation is the reverse procedure. Put the Left Shroud in
postion first to align the screws for the Right Shroud. Install the top
screws first.
NOTICE: Be sure not to crimp any cables. Be sure the tabs in
the Top Shroud snap into the Main Assembly.
130 bike—To reinstall the Pedals, carefully align the threads and
hand tighten to prevent cross-threading. Then tighten fully with
pedal wrench.
Note: The Left Pedal is reverse-threaded. Orientation is based
from a seated position on the bike. The Left Pedal has an
"L", the Right Pedal an "R".
14. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
33