Power Inlet - Schwinn Journey 1.0 Service Manual

3. Loosen and remove the thin Nut from the Power Inlet (C) on the
outside of the Shroud.
4. Pull the Power Inlet plug (C) out of the hole toward the inside
of the Shroud. Discard the old Power Inlet assembly.
5. Installation is the reverse procedure.
NOTICE: Do not crimp any cables. Be sure the Power Inlet
plug is seated evenly in the hole.
6. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
C
C
A
62
A
C