Schwinn Journey 1.0 Service Manual page 35

Disconnect all power to the machine before you service it.
Note: Your machine may not match the image. For reference only.
1. Remove screws that attach Console to the Mast. Carefully lift
the Console off the Mast.
2. Disconnect the Data Cable and Heart Rate Cable from the
back of the Console. Set the Console and screws safely aside for
reassembly.
Note: Do not let the cables fall down inside the Mast. This step
may require two people.
3. Remove the Handlebar Bracket Cover and set it safely aside
for reassmbly.
4. Tie the length of string to the end of the Heart Rate Cable at the
top of the Mast. Grasp the section of HR Cable under the Handlebar
Bracket and carefully pull the cable and string down through the
Mast and out of the hole so that the string extends through the the
Mast and Handlebar Bracket.
Note: Do not let the Data Cable fall down inside the Mast.
35