Network - urmet domus 1099 User Manual

7.2.2

NETWORK

1) Network configuration
Click on 【Network】→【Network Setting】 to access the following network.
This page can be used to display and set the parameters related to the LAN of the camera:
➢
Type: DHCP, Static or PPoE. The default setting is Static.
➢
Command Port: This is the default command port of the IP camera. 6060
➢
HTTP Port: This is the default web port of the IP camera. 80
➢
IP address: Camera IP address
➢
Subnet Mask: Subnet mask of the IP camera.
➢
Gateway: IP address of the gateway used to access the Internet
➢
DNS1/DNS2: IP addresses of the DNS servers.
➢
Media Port: This is the default client port of the IP camera. 6066
➢
MAC address: This is the MAC address of the LAN board of the camera.
It is advisable to set a static IP address after having appropriately connected and configured the camera in the network, only
in case of camera recording to HVR/NVR. Make sure that the IP address you want to assign to the camera is not already used
in the network. It is better to use an address outside the range of addresses assigned by means of DHCP.
Select "Type = Static" and fill in the following fields: IP address, Subnet mask, Gateway and DNS. Press Save to save the
changes.
12 DS1099-164