Table of Contents
Advertisement
5.
To check the connection of the camera in 4G to the internet, connect a personal device such as a
smartphone/tablet/PC to the Wi-Fi network of the camera (Wi-Fi SSID): "MIFI_...", Wi-Fi password:
1234567890) or connect a PC via cable to the network connector of the camera.
6.
The integrated 4G/Wi-Fi router provides internet access to the camera and also to devices connected via Wi-Fi
or cable to the camera.
For remote viewing of the camera from a smartphone/tablet device, see section 4 of this guide.
To access the advanced configurations of the built-in 4G/Wi-Fi router of the camera, see section 5 of this guide.
4
HOW TO CONFIGURE THE CAMERA IN A NETWORK
In this section explanation is provided to configure the camera in the network and to connect it remotely from the smartphone
App or from a PC.
IMPORTANT NOTE: the camera is provided with two different network boards, one for the wire connection and one for the
WiFi connection, each with its own MAC address and is own IP address.
4.1
HOW TO ADD THE CAMERA TO A WIFI NETWORK FROM THE APP
The camera can be quickly configured on the WiFi network using a smartphone, to do so refer to the paper Quick Guide of
the Urmet App V-Stream provided with the product:
Alternatively, the camera can be also configured on the WiFi network without making use of the smartphone, i.e. using a PC
in either way: by temporarily wiring the camera to the LAN (see § 4.3) or in ACCESS POINT mode (see § 4.4).
4.2
STATIC IP ADDRESS ALLOCATION
The network parameters of the camera, such as IP address, subnet mask and gateway may be set and modified using
"EasyTool" provided or on the camera web page.
If the camera has to be recorded by a HVR/NVR device it is advisable to set a static IP address after having appropriately
connected and configured the camera in the network (see previous sections). Make sure that the IP address you want to
assign to the camera is not already used in the network. It is better to use an address outside the range of addresses assigned
by means of DHCP.
To assign the static IP address, select the camera after having detected it in "EasyTool". As shown in the figure below, fill in
the static network parameter to be assigned (the fields are filled in automatically by selecting the correct network interface
from those available on the PC) in the specific section of the tool.
6
V-Stream
DS1099-077
Advertisement
Table of Contents
