7.2.5
ADVANCED
The 【Firmware Update】, 【Load Default】 and 【Maintain】 options are present, as shown in the following figure. .
1)
Firmware upgrade
Click on 【Advanced】→【Firmware Update】 to access the following interface.
The "Firmware Update" option can be used to "Scan" to select the update file; click on Upgrade to update the system
automatically. If the update file does not correspond to the device, the update will not be performed.
IMPORTANT NOTE: The firmware update procedure will last for approximately 5 minutes. Do not interrupt the power supply
or disconnect from the network during the update.
2)
Default parameter loading
Click on 【Advanced】→【Load Default】 to access the following interface.
Select "Reset factory settings" and press the Save button to restore all default setting except for: network parameters (LAN),
user Password, NTP, DST, channel name.
Select "Full Reset factory settings" and press the Save button to restore all factory settings.
Click on "Reboot" and press the Save button to restart the device.
20
DS1099-164