Table of Contents
Advertisement
Servicing
EKEVO 6/EKEVO 7
Rotation procedure of air box
03/2016 - Art. Nr. 4200 1044 8002A
Rotation procedure of air box
1.
Remove the flexible air hose.
2.
Disassemble the servomotor from
the air flap and fasten it to the
casing.
3.
Disassemble the cover of the air
box.
4.
Unfasten the air box support,
swing it towards the new desired
position and fasten it again
(rotation possible in 45° steps)
5.
Put the air box cover back on.
6.
Remove the original pressure
connection hose and place it in
position 2 (this location has a
factory-assembled plug)
7.
Fit the hose again and remove the
clamp fitting (plug the hole again
with the screw)
8.
Cut all the clamp fittings along the
power supply cable of the
servomotor as far as the switch
cabinet.
9.
Remove the power supply cable
from the servomotor and fasten it
in its new position (if there is no
Namur sensor, no action is
needed in the cabinet wiring)
10.
Fit the cable again by following a
new path (bottom of rear side)
11.
Fit 2 additional clamp fittings for
the power supply cable (2
adhesive pieces and clamps are
provided as accessories)
12.
2 graduated scales indicate the
position of the air flap
Burner assembly label
If the air box was rotated, the label
may be upside down. Stick a new
label (provided with the
accessories) on the old one to
make it easy to read.
61
Advertisement
Table of Contents
