Operating Position; Lifting Points; Installation Of The Support For Burner Opening - Riello DR 32 SE FGR Installation, Use And Maintenance Instructions

4.4

Operating position

 The burner is designed to work only in posi-
tions 1, 2, 3 and 4 (Fig. 11).
 The installation 4 permits the operation, but
makes the maintenance and inspection oper-
WARNING
ations of the combustion head more difficult.
1
4.5

Lifting points

Prepare an adequate lifting system.
To move the burner, only use the attachment
points A shown in Fig. 12.
4.6

Installation of the support for burner opening

To install the support for the burner opening proceed as indicated
in Fig. 13:
 remove the split pin 2) and the pin from its site.
 Insert the support for the burner opening 3) in its casing 4)
until the hole on the support 3) matches the pin 1).
 Insert the pin 1) again and the split pin 2) in its seat so as to
lock the support 3).
Installation
2 3
17 GB
 To the burner in position 5, direct the pilot gas
train 17)(Fig. 6 a pag. 11) as indicated in
position 1. In order to carry out this operation,
disassemble the pilot gas train and install it
DANGER
upside down.
4
20188930
20188935
20188944
5
Fig. 11
Fig. 12
Fig. 13
20188797