Table of Contents
Advertisement
5.4
Operating position
The burner is designed to operate only in
positions 1, 2, 3 and 4 (Fig. 10).
Installation 1 is preferable, as it is the only
one that allows the maintenance operations
WARNING
as described in this manual.
Installations 2, 3 and 4 permit operation but
make maintenance and inspection of the
combustion head more difficult.
Any other position could compromise the cor-
rect operation of the appliance.
Installation 5 is prohibited for safety reasons.
DANGER
5.5
Removal of the locking screws from the shutter
Remove the screws and the nuts 1)-2)(Fig. 11),
before installing the burner on the boiler.
Replace them with the screws 3) M12 X 16 sup-
WARNING
plied with the burner.
5.6
Preparing the boiler
5.6.1
Boring the boiler plate
Pierce the closing plate of the combustion chamber, as in Fig. 12.
The position of the threaded holes can be marked using the ther-
mal insulation screen supplied with the burner.
5.6.2
Blast tube length
The length of the blast tube must be selected according to the in-
dications provided by the manufacturer of the boiler, and in any
case it must be greater than the thickness of the boiler door com-
plete with its refractory.
For boilers with front flue passes 1)(Fig. 13) or flame inversion
chamber, a protection in refractory material 5) must be inserted
between the boiler fettling 2) and the flame funnel 4).
This protection must not compromise the extraction of the blast
tube.
For boilers with a water-cooled frontpiece, a refractory lining 2)-
5)(Fig. 13) is not necessary, unless expressly requested by the
boiler manufacturer.
20160598
Installation
1
1
2
2
1
mm
RS 810/M BLU
16
GB
2
3
4
D7739
D12015
D 1
20149117
D F
Ø
D1
DF
400
495
5
Fig. 10
3
3
Fig. 11
Fig. 12
M18
Tab. G
Advertisement
Table of Contents
