Error Messages - Duerkopp Adler 869-M PREMIUM Operating Instructions Manual

148

10.2.2 Error messages

Code Possible cause
1000 Sewing motor encoder
plug (Sub-D, 9-pin) not
connected
1001 Sewing motor error:
Sewing motor plug
(AMP) not connected
1002 Sewing motor
insulation fault
1004 Sewing motor error:
incorrect sewing motor
direction of rotation
1005 Motor blocked
1006 Maximum speed
exceeded
1007 Error in the reference
run
Operating Instructions 868-M PREMIUM - 02.0 - 01/2018
Troubleshooting
Remedial action
• Connect encoder cable to the
control, use correct connection
• Check connection and plug in, if
necessary
• Test sewing motor phases
, high impedance to PE)
(R= 2.8 Ω
• Replace the encoder
• Replace sewing motor
• Replace the control
• Check motor phase and PE for
low-impedance connection
• Replace the encoder
• Replace sewing motor
• Replace the encoder
• Check plug assignment and
replace, if necessary
• Check wiring in machine distributor
and change it, if necessary
• Test motor phases and check for
correct value
• Eliminate stiff movement in the
sewing machine
• Replace the encoder
• Replace the motor
• Replace the encoder
• Perform reset
• Check machine class
(parameter t 51 04)
• Replace the encoder
• Eliminate stiff movement in the
sewing machine