Creating A Program Using Teach-In - Duerkopp Adler 869-M PREMIUM Operating Instructions Manual

Programming
Operating Instructions 868-M PREMIUM - 02.0 - 01/2018
5.6.3

Creating a program using Teach-In

Creating a program using Teach-In is done by sewing the seam
sections and manually entering the parameters for the seam
sections and the program.
To create a program using Teach-In:
Create a new program,  p. 94.
1.
2. Press the Teach-In
 The following display is shown, with preset values which can
be specified at technician level.
Fig. 47: Programming mode display
3. Set the basic parameters that are explained in the table.
Symbol Meaning
Stitch length for the current seam section
Value range: 00.0 - 12.0 [mm] (depending on the subclass)
• Use ◄/► to select the Stitch length parameter
• Use ▲/▼ to change the stitch length
Needle thread tension value (%) of current seam section
Value range: 00 - 99
• Use ◄/► to select the Needle thread tension parameter
• Use ▲/▼ to change the needle thread tension.
Information
If the values for the needle thread tension of the right and
the left needle thread are not identical and changed jointly,
the difference remains the same.
2-needle machines
• Use ◄/► to select the needle thread tension parameter
• Press the OK button to open the submenu
• Use ▲/▼ to select the right or the left needle thread
• Press the OK button to confirm
• Use ▲/▼ to change the needle thread tension
• Press the OK button to confirm
button.
- 1 4.5 25 5 2.0
+
0
97