Table of Contents
Advertisement
76
Setting: Monitor (Monitor)
Monitor mode can only be used if the additional equipment of the
remaining thread monitor is present on the machine. Monitor mode
allows for optical monitoring of the bobbin. The possible settings
are listed in the table.
t Clean
Value range 0000 – 5000 [ms]
Motor Stop
ON/OFF
Setting: Software (Softw.)
In Software mode, the bobbin is monitored by the software based
on the number of stitches sewn. The possible settings are listed
in the table.
Counter type
A/B/C/D
Counter
Value range 00000 – 99999
Motor Stop
ON/OFF
ResetNeces
ON/OFF
Operating Instructions 868-M PREMIUM - 02.0 - 01/2018
Duration for which the lens is blown
clear with compressed air. The process
takes place as the thread is cut.
Sewing stops and a notice is shown
on the display when the bobbin is
detected to be nearly empty. If the
parameter is not activated, only the
LEDs on the machine arm give a
warning if the bobbin is empty.
4 different counters can be applied.
The following 3 subitems can be set for
each of the counters.
Bobbin supply capacity in stitches.
This is a very variable value, which
depends on the size of the bobbin and
the thickness of the thread.
Sewing stops and a notice is shown on
the display when the bobbin is detected
to be nearly empty. If the parameter is
not activated, only the LEDs on the
machine arm give a warning if the
bobbin is empty.
It is only possible to resume sewing after
changing the bobbin and confirming the
message on the control panel.
Programming
Advertisement
Table of Contents
