Table of Contents
Advertisement
78
5.4.11 Setting the Puller parameter (Puller)
The puller supports the transport of the sewing material. The feed
of the two rollers is calculated automatically based on the stitch
length of the machine. An adjustment may be necessary depend-
ing on the application.
The rollers of the puller can be adjusted separately. The input is
in percent: a positive value increases the roller feed while a
negative value reduces the feed.
Menu item
Top Cor.
Correction top roller
Bottom Cor.
Correction bottom roller
5.4.12 Setting the Edge stop parameter (EdgeGuide)
The edge stop helps to precisely position the sewing material.
The value set indicates the distance between the needle and edge
stop/material edge.
nd
The 2
distance for the edge stop can only be accessed using
the softkey menu button or the softkey button if these are
nd
assigned to the 2
Menu item
Distance
Edge guide
Gap (+)
nd
Edge stop 2
Distance
Operating Instructions 868-M PREMIUM - 02.0 - 01/2018
Setting option
Value range -100 – 100 [%]
Value range -100 – 100 [%]
distance.
Setting option
Value range 01.0 – 45.0 [mm]
Value range 01.0 – 45.0 [mm]
Programming
Advertisement
Table of Contents
