Setting The End Bartack Parameter (End Tack) - Duerkopp Adler 869-M PREMIUM Operating Instructions Manual

72
Setting: Invert direction (Invert Dir.)
Normally, a bartack starts either with the sewing direction
(forwards – even number of sections) or against the sewing
direction (backwards – odd number of sections), depending on
the number of sections.
Setting this parameter inverts the sewing direction of the bartack.
5.4.7

Setting the End bartack parameter (End Tack)

There are various options for setting the end bartack. All subitems
in the End Tack menu are listed in the following table.
Settings that are more complex and therefore require further
explanation are described in more detail in the chapter on the start
bartack ( p. 68) or below the table.
Menu items
On
Stitches (↑)
Number of backward
stitches
Stitches (↓)
Number of forward
stitches
Repetitions,
Number of sections
in a bartack
 p. 70
t Change,
Waiting time at turning
points
 p. 70
St.Len.Def.,
Default stitch length
 p. 70
Operating Instructions 868-M PREMIUM - 02.0 - 01/2018
Setting option 1
ON/OFF
Value range
01 – 50
Value range
01 – 50
Value range
01 – 99
Value range
0000 – 1000 [ms]
ON/OFF
St.Len. (↑)
St.Len. (↓)
Programming
Setting option 2
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Value range
01.0 – 12.0 [mm]
(depending on subclass)