Rs485 Full-Duplex Interface - Datalogic DS2100N Reference Manual

CBX ELECTRICAL CONNECTIONS

4.2.2 RS485 Full-Duplex Interface

The RS485 full-duplex (5 wires + shield) interface is used for non-polled communication
protocols in point-to-point connections over longer distances (max 1200 m / 3940 ft) than
those acceptable for RS232 communications or in electrically noisy environments.
The CBX pinout follows:
CBX100/500
TX+
RX+
TX-
RX-
SGND
For applications that do not use RX485 signals, do not leave these lines
floating but connect them to SGND as shown below.
NOTE
Figure 24 - RS485 Full-duplex Connections using Only TX Signals
Function
RS485 Transmit Data +
RS485 Receive Data +
RS485 Transmit Data -
RS485 Receive Data -
Signal Ground
SCANNER SGND TX+
Figure 23 - RS485 Full-duplex Connections
SGND TX+
SCANNER
USER INTERFACE
RX485+ TX485+
SGND RX485- TX485-
RX+
TX- RX-
USER INTERFACE
RX485+
SGND RX485-
TX-
4
33