Power Supply; Main Serial Interface - Datalogic DS2100N Reference Manual

25-PIN CABLE ELECTRICAL CONNECTIONS

5.1 POWER SUPPLY

Power can be supplied to the scanner through the pins provided on the 25-pin connector
used for communication with the host (Figure 44):
The power must be between 10 and 30 Vdc only.
It is recommended to connect pin 1 (CHASSIS) to a common earth ground.

5.2 MAIN SERIAL INTERFACE

The signals relative to the following serial interface types are available on the input/output
connector of DS2100N.
If the interface type is not compatible with the current communication handshaking, then the
system forces the handshake to none.
The main interface type and the relative parameters (baud rate, data bits, etc.) can be
set using the Genius™ utility program or the Genius™ based Host Mode Programming
procedure.
Details regarding the connections and use of the interfaces are given in the next paragraphs.
DS2100N
13 Vdc
25
GND
1
CHASSIS
Earth Ground
Figure 44 - Power Supply Connections
POWER SUPPLY
V+ (10 - 30 Vdc)
VGND
CHASSIS
5
49