Datalogic DS2100N Reference Manual page 81

TYPICAL LAYOUTS
Alternatively, the Master scanner can communicate to the Host as a Slave node on a
Fieldbus network. This requires using an accessory Fieldbus interface board installed inside
the CBX500 connection box.
System configuration can be accomplished through the Auxiliary interface of the Master
scanner (internal CBX500 9-pin connector) using the Genius™ configuration program or
Genius™ based Host Mode programming.
Power
Master
1
Host
Power
Master
3
1
3
Slave#1
2
Figure 73 – ID-NET™ Fieldbus M/S Synchronized Layout
4
Slave#1
Host
Figure 74 – ID-NET™ Fieldbus M/S Multidata
Fieldbus Interface
External Trigger (for On-Line Mode)
ID-NET™ (up to 16 devices - practical limit)
2
Terminal
Fieldbus Interface
Auxiliary Serial Interface (Local Echo) (RS232)
External Trigger (for On-Line Mode)
ID-NET™ (up to 32 devices, max network extension of 1000 m)
6
Slave#n
Slave#n
71