Step 3 - X-Press™ Configuration - Datalogic DS2100N Reference Manual

RAPID CONFIGURATION
STEP 3 – X-PRESS™ CONFIGURATION
X-PRESS™ is the intuitive Human Machine Interface designed to improve ease of
installation and maintenance.
Status and diagnostic information are clearly presented by means of the five colored LEDs,
whereas the single push button gives immediate access to the following relevant functions:
AutoSetup to self-optimize and auto-configure
•
reading performance in demanding applications
AutoLearn to self-detect and auto-configure for
•
reading unknown barcodes (by type and length)
Test Mode with bar-graph visualization to check
•
static reading performance
If using the OM2000N accessory, when entering the X-PRESS™ interface, the
Oscillating Mirror remains in the default fixed position (-15°) in order to make
barcode reading easier while performing the X-PRESS™ functions.
NOTE
The colors and meaning of the five LEDs are illustrated in the following table:
READY (green)
GOOD (green)
TRIGGER (yellow)
COM (yellow)
STATUS (red)
* When connected to a Fieldbus network through the CBX500, the COM LED is always active, even in the
absence of data transmission, because of polling activity on the Fieldbus network.
During the reader startup (reset or restart phase), all the LEDs blink for one second.
On the back of the reader near the cable, the "POWER ON" LED indicates the laser scanner
is correctly powered.
This LED indicates the device is ready to operate.
This LED confirms successful reading.
This LED indicates the status of the reading phase.
This LED indicates active communication on main serial port. *
This LED indicates a NO READ result.
1
5