Fieldmann FZP 70105-0 Manual page 21

exceeding part by means of a flat file to round off the depth delimiting device.
7. Ensure that the chain is replaced before stretching to exceed the maximum adjustment of the chain saw bar.
8. 'Deep' filing should be performed with an electric file , we advise to use a service centre to perform this
operation.
9. Ensure that the chain slides smoothly over the bar when pulled with hands, periodically sharpen chain and
check the chain tension.
10. Bars with sprockets need frequent greasing which can be performed as follows :
- Fill a syringe or similar device with grease for bearings.
- Each time the saw is used grease through the hole provided near the bar tip until the grease penetrated
onto the tip.
- After 3 times of sharpening the chain your self have it professionally sharpened, this will ensure that all
the teeth are even.
To avoid damage to the motor, do not keep the chain saw running if the chain is lodged in the wood.
Fig. 1 8
CORDLESS MINI CHAINSAW
Cleaning and maintenance
Fig. 1 9
21
Fig.20
USER'S MANUAL
EN