Fieldmann FZP 70105-0 Manual page 12

EN 12
Functional description
1. Before adjusting chain, make sure guide bar nuts are only finger tight. Also make sure adjusting block is in
oval adjusting hole on guide bar.
2. Turn adjusting screw clockwise until all slack is out of chain.
Note: There should be no gap between side likes of chain ad bottom of guide bar.
3. Wearing protective gloves, move chain around guide bar, chain should move freely. If chain does no move
freely. Loosen chain by turning adjusting screw counterclockwise.
4. After chain tension is correct , tighten guide bar nuts firmly. If not, guide bar will move and loosen chain
tension. This will increase the risk of kickback , this can also damage saw, Note: a new chain will stretch,
check new chain after first few minutes of operation. Allow chain to cool down. Readjust chain tension.
WARNING!
Do not over tension the chain as this will lead to excessive wear and will reduce the life of bar and chain. Over
tensioning also reduce the amount of cuts you should get.
Oil filling
Note: The chain saw is shipped without oil in it, the chain saw must never be used without oil or with an oil
level that is below the indicator.
WARNING! Always ensure that the chainsaw is switched off ad the plug is removed from the power point
before making any adjustments.
1. Remove oil cap. (fig.7)
Fig.6
Fig.7
FZP 70105-0