Fieldmann FZP 70105-0 Manual page 13

2. Fill oil tank with chain lubricating oil.
3. Check the oil level periodically, through the oil level indicator (fig.8).
4. Tighten oil cap firmly for good seal, this will avoid oil seepage from tank.
5. Wipe off excess oil.
Note: It is normal for oil to seep when saw is not in use. Empty oil tank after each use to prevent seepage.
Checking the automatic oil function
Check the automatic operation of the chain lubrication by pointing the tip of the switched –on saw towards
a piece of paper laying on the ground, if a patch of oil appears and becomes larger, then the automatic oil
function is working. If there are no traces of oil even though the oil tank is full. Then the automatic oil function
is not working.
If the automatic oil function is not working . remove the chain bar and clean out the oil ways of the chainsaw
and chain bar, on reassemble if the chainsaw is still not working take it to a autorised if the chainsaw is still
not working take it to an autorised service centre.
Avoid jamming
Always cut into the compression wood first until the cut starts to close. Always make the compression cut
beneath if the log or limb is suspended from one end, and on top if it is supported at both ends, cut from
the other side towards the compression cut, make a habit of using a wedge to prevent the compression cut
jamming tight on the chainsaw blade.
CORDLESS MINI CHAINSAW
(
Fig.8
Functional description
USER'S MANUAL
13 EN