Configuration File Maintenance; Using A Different Configuration File - ZyXEL Communications ZyXEL Dimension ES-3148 User Manual

ES-3148 User's Guide
where
copy running-config
interface port-
channel <port>
<port-list>
copy running-config
interface port-
channel <port>
<port-list>
[active
... ]
An example is shown next.
• Copy all attributes of port 1 to port 2
• Copy selected attributes (active, bandwidth limit and STP settings) to ports 5-8
sysname# copy running-config interface port-channel 1 2
sysname# copy running-config interface port-channel 1 5-8 active
bandwidth-limit spanning-tree

35.6 Configuration File Maintenance

The following sections shows how to manage the configuration files.

35.6.1 Using a Different Configuration File

You can store up to two configuration files on the switch. Only one configuration file is used
at a time. By default the switch uses the first configuration file (with an index number of 1).
You can set the switch to use a different configuration file. There are two ways in which you
can set the switch to use a different configuration file: restart the switch (cold reboot) and
restart the system (warm reboot).
Use the
boot config
specified). The following example restarts the switch to use the second configuration file.
sysname# boot config 2
Use the
reload config
(if specified). The following example restarts the system to use the second configuration file.
sysname# reload config 2
268
= Copies all of the possible attributes from one port to another port
or ports.
= Copies only the specified port attributes from one port to another
port or ports.
command to restart the switch and use a different configuration file (if
command to restart the system and use a different configuration file
Chapter 35 User and Enable Mode Commands