ES-3148 User's Guide
34.9 Using Command History
The switch keeps a list of recently used commands available to you for reuse. You can use any
commands in the history again by pressing the up ( ) or down ( ) arrow key to scroll through
the previously used commands and press
of commands.
sysname> history
enable
exit
show ip
history
sysname>
34.10 Saving Your Configuration
After you set the switch settings with the configuration commands, use the
command to save the changes permanently.
Note: The
You must save your changes after each CLI session. All unsaved configuration
changes are lost once you restart the switch.
sysname# write memory
34.10.1 Switch Configuration File
When you configure the switch using either the CLI (Command Line Interface) or web
configurator, the settings are saved as a series of commands in a configuration file on the
switch. You can perform the following with a configuration file:
• Back up switch configuration once the switch is set up to work in your network.
• Restore switch configuration.
• Use the same configuration file to set all switches (of the same model) in your network to
the same settings.
Note: You may also edit a configuration file using a text editor.
Make sure you use valid commands. The switch rejects configuration files with
invalid or incomplete commands.
236
command is not available in User mode.
write memory
. Use the history command to display the list
[ENTER]
Chapter 34 Introducing Commands
write memory