Gvrp Timer; Enable Gvrp; Disable Gvrp; Port Vlan Commands - ZyXEL Communications ZyXEL Dimension ES-3148 User Manual

Switches join VLANs by making a declaration. A declaration is made by issuing a Join
message using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All
message terminates all registrations. GARP timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800
milliseconds and the Leave All Timer to 11000 milliseconds.
sysname (config)# garp join 300 leave 800 leaveall 11000

38.2.3 GVRP Timer

Syntax:
This command shows the switch's GVRP settings.
An example is shown next.
sysname # show vlan1q gvrp
GVRP Support
---------------------
gvrpEnable = YES
sysname #

38.2.4 Enable GVRP

Syntax:
This command turns on GVRP in order to propagate VLAN information beyond the switch.

38.2.5 Disable GVRP

Syntax:
This command turns off GVRP so that the switch does not propagate VLAN information to
other switches.

38.3 Port VLAN Commands

You must configure the switch port VLAN settings in config-interface mode.
Chapter 38 IEEE 802.1Q Tagged VLAN Commands
show vlan1q gvrp
vlan1q gvrp
no vlan1q gvrp
ES-3148 User's Guide
295