ES-2048 User's Guide
24.3.3 Configuring SNMP
From the Access Control screen, display the SNMP screen. You can click Access Control to
go back to the Access Control screen.
Figure 83 Access Control: SNMP
The following table describes the labels in this screen.
Table 55 Access Control: SNMP
LABEL
Get Community
Set Community
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP
Trap Destination
Apply
Cancel
24.4 Setting Up Login Accounts
Up to five people (one administrator and four non-administrators) may access the switch via
web configurator at any one time.
• An administrator is someone who can both view and configure switch changes. The
username for the Administrator is always admin. The default administrator password is
1234.
180
DESCRIPTION
Enter the get community, which is the password for the incoming Get- and GetNext-
requests from the management station.
Enter the set community, which is the password for incoming Set- requests from the
management station.
manager.
Enter the IP addresses of up to four stations to send your SNMP traps to.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to reset the fields.
Chapter 24 Access Control