Enabling Mac Filtering - ZyXEL Communications ZyXEL Dimension ES-2048 User Manual

[metric <metric>]
[name <name>]
[inactive]
An example is shown next.
• Create a static route with the destination IP address of 172.21.1.104, subnet mask of
255.255.0.0 and the gateway IP address of 192.168.1.2.
• Assigns a metric value of 2 to the static route.
• Assigns the name "route1" to the static route.
sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2
sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2 metric 2
sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2 name route1

33.7 Enabling MAC Filtering

You can create a filter to drop packets based on the MAC address of the source or the
destination.
Syntax:
mac-filter name <name> mac <mac-addr> vlan <vlan-id> drop <src/dst/both>
where
name <name>
mac <mac-addr>
Chapter 33 Configuration Mode Commands
= The metric represents the "cost" of transmission for routing
purposes. IP routing uses hop count as the measurement of
cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and
15. In practice, 2 or 3 is usually a good number.
= Specifies a descriptive name (up to 32 printable ASCII
characters) for identification purposes.
= Deactivates a static route
= Names the filtering rule.
= Specifies the MAC address you want to filter.
ES-2048 User's Guide
257