Figure 25 Status; Table 6 Status - ZyXEL Communications ZyXEL Dimension ES-2048 User Manual

ES-2048 User's Guide

Figure 25 Status

The following table describes the labels in this screen.

Table 6 Status

LABEL
Port
Name
Link
State
LACP
TxPkts
62
DESCRIPTION
This identifies the Ethernet port. Click a port number to display the Port Details
screen (refer to Figure 26 on page
This is the name you assigned to this port in the Basic Setting, Port Setup screen.
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or 1000M
for 1000Mbps) and the duplex (F for full duplex or H for half). It also shows the cable
type (Copper or Fiber) for the combo ports.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port (see Section 11.1 on page 105
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP.
This fields displays whether LACP (Link Aggregation Control Protocol) has been
enabled on the port.
This field shows the number of transmitted frames on this port.
64).
for more information).
Chapter 6 System Status and Port Statistics