IEEE 802.1Q Tagged VLAN
This chapter describes the IEEE 802.1Q Tagged VLAN and associated commands.
35.1 Configuring Tagged VLAN
The following procedure shows you how to configure tagged VLAN.
1 Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the
switch.
• Use the
switch automatically enters the
deactivate the VLAN(s).
• Use the
interface mode to set the VLAN settings on a port, then use the pvid <vlan-id>
command to set the VLAN ID you created for the port-list to that specific port in the
PVID table.
• Use the
sysname (config)# vlan 2000
sysname (config-vlan)# name up1
sysname (config-vlan)# fixed 5-8
sysname (config-vlan)# no untagged 5-8
sysname (config-vlan)# exit
sysname (config)# interface port-channel 5-8
sysname (config-interface)# pvid 2000
sysname (config-interface)# exit
2 Configure your management VLAN.
• Use the
managing the switch, and the switch will activate the new management VLAN.
• Use the
sysname (config)# vlan 3
sysname (config-vlan)# inactive
Chapter 35 IEEE 802.1Q Tagged VLAN Commands
command to configure or create a VLAN on the switch. The
vlan <vlan-id>
config-vlan
interface port-channel <port-list> command
command when you are finished configuring the VLAN.
exit
command to create a VLAN (VID 3 in this example) for
vlan <vlan-id>
command to disable the new management VLAN.
inactive
C
H A P T E R
Commands
mode.Use the
ES-2048 User's Guide
3 5
command to
inactive
to enter the config-
271