ZyXEL Communications ZyXEL Dimension ES-2048 User Manual page 225

Table 72 Command Summary: Enable Mode (continued)
COMMAND
baudrate <1|2|3|4|5>
boot config <index>
reload config <index>
write memory
copy tftp flash <ip>
<remote-file>
tftp config
<index> <ip>
<remote-file>
running-config
tftp <ip>
<remote-file>
running-config
interface port-
channel <port>
<port-list>
running-config
interface port-
channel <port>
<port-list>
cable- <port-list>
diagnostic
s
ping <ip|host-name>
help
Chapter 31 Introducing Commands
DESCRIPTION
Resets to the factory default
interface port-
settings on a per port basis and
channel <port-
optionally on a per feature
list>
configuration basis.
[bandwidth-
limit...]
Changes the console port speed.
Choices are 1 (9600), 2 (19200),
3(38400), 4 (57600) and 5
(115200).
Restarts the system with the
specified configuration file.
Restarts the system and use the
specified configuration file.
Saves current configuration to the
configuration file the switch is
currently using.
Saves current configuration to the
<index>
specified configuration file on the
switch.
Restores firmware via TFTP.
Restores configuration with the
specified filename from the
specified TFTP server.
Backs up running configuration to
the specified TFTP server with
the specified file name.
Clones (copies) the attributes
from the specified port to other
ports.
Copies the specified attributes
[bandwidth-
from one port to other ports.
limit ....]
Performs a basic connectivity test
on the ports. Displays "Ok" if
connector is inserted in the port,
"Open" if no connector is inserted
in the port or "Unknown" if this
test cannot determine the status.
Sends Ping request to an
Ethernet device.
Sends Ping request to an
[vlan <vlan-
Ethernet device in the specified
id>][..]
VLAN(s).
Displays command help
information.
ES-2048 User's Guide
PRIVILEGE
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
223