ZyXEL Communications ZyXEL Dimension ES-2048 User Manual page 117

Table 26 Bandwidth Control (continued)
LABEL
*
Ingress Rate
Active
Commit
Rate
Active
Peak Rate Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the incoming
Active
Egress Rate
Apply
Cancel
Chapter 12 Bandwidth Control
DESCRIPTION
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this check box to activate commit rate limits on this port.
Specify the guaranteed bandwidth allowed in kilobits per second (Kbps) for the
incoming traffic flow on a port. The commit rate should be less than the peak rate. The
sum of commit rates cannot be greater than or equal to the uplink bandwidth.
Select this check box to activate peak rate limits on this port.
traffic flow on a port.
Select this check box to activate egress rate limits on this port.
Specify the maximum bandwidth allowed in kilobits per second (Kbps) for the out-going
traffic flow on a port.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields.
ES-2048 User's Guide
115