Reset (Load Factory Settings) - Weco Cruiser Power Pulse Instruction Manual

Cod. 006.0001.1680
09/06/2020 V.2.10
ENGLISH
5

RESET (LOAD FACTORY SETTINGS)

L4 L5 D1
L1
rEC
L2
L3
L19
L15
L18
L16
L17
S1
ACTIVATION/
A
SELECTION
The reset procedure involves complete restoration of the default values, parameters and memory set-
tings set in the factory.
The reset procedure is useful in the following cases:
- Too many changes made to the welding parameters so user finds it difficult to restore defaults.
- Unidentified software problems that prevent the welding power source from functioning correctly.
PARTIAL RESET
The reset procedure involves restoration of the parameter values and settings, except the following
settings:
- Settings of the SETUP menu.
- Saved JOBS.
TOTAL RESET
The reset procedure involves complete restoration of the default values, parameters and memory set-
tings set in the factory.
All memory locations will be reset and hence all your personal welding settings will be lost!
○ Set the welding power source ON/OFF switch to "O" to switch the unit off.
○ Keeping both the S1
A
switch to "I" to turn on the equipment [
- rEC PAr: The message appears on the following displays: D1-D2.
B
○ Select encoder E1
14
WELD TH E W O R L D
L6 L7 D2 L8
PAr
L20 L21
L23
L25
L26
L24
L22
L27
S2 S3 L28 L29 S4
C
EXIT
and S6
with the following setting: rEC PAr (partial) or rEC FAC (total).
Power Pulse 322/402/502T
L9 L10 L11 L12 L13L14 E1
L30 L31 S5 L34 S6
A
ACTIVATION
buttons pressed, set the generator power source
SIMULTANEOUS ACTIONS]
Cruiser 322/402/502T
B
SETTING
L32
L33
L38
L35
L36
L37