Pre-Fitting The Mounting Bracket On The Access Point - Allied Telesis AT-TQ6602 GEN2 Installation Manual

Chapter 2: Installing the Wireless Access Point

Pre-fitting the Mounting Bracket on the Access Point

40
To pre-fit the mounting bracket on the access point, perform the following
procedure:
1. Place the wireless access point upside down on a table.
2. Install the two screws (provided) fully into the bottom panel of the
access point. See Figure 13.
Figure 13. Attaching the Bracket Screws to the Access Point
The screw collar provides the proper spacing for the mounting bracket
beneath the screw head. See Figure 14.
Figure 14. Panel Screw
Collar