Allied Telesis AT-TQ6602 GEN2 Installation Manual page 47

2. Connect the other end of the Ethernet cable to a network Ethernet
device, such as an Ethernet switch or router.
Note
If the device is PoE+ power sourcing equipment (PSE), the access
point begins to power on and initialize its management software.
3. To use LAN2 port in the static LAG or Cascade mode, connect a
second Ethernet cable to the port. See Figure 23.
Figure 23. Connecting the Ethernet Cable to the LAN2 Port
4. Connect the other end to a network device. To use the port as a static
LAG with the LAN1 port, connect it to the same router or switch as
LAN1 port. To use it in the Cascade mode, connect it to a different
device. For an overview, refer to "Static Link Aggregation" on page 23
and "Cascade Mode" on page 24.
Note
The default setting for the LAN2 port is disabled, To set it to the
Static LAG or Cascade mode, use the on-board web browser
management interface, explained in the TQ6000 GEN2
Management Software User Guide.
5. Do one of the following:
a. If the access point is to be power only by PoE+, without an AC
power adapter, go to "Attaching the Access Point to the Mounting
Bracket" on page 49.
b. To connect an external AC power adapter, go to "Connecting the
AC Power Adapter".
TQ6602 GEN2 Access Points Installation Guide
47