Getting Status And Setting Options By Rdm; Rdm Functions - Harman Martin RUSH MH 10 Beam FX User Manual

each device's factory-set unique identifier (UID). This process can take some
time depending on the number of devices on the link.
To identify the fixtures on the link:
Check that the fixtures are correctly connected to the RDM controller on the
data link and that power is applied to all fixtures.
1. In Martin® M-PC, go to RDM CONTROLLER  DISCOVER DEVICES.
2. Give the controller time to identify the devices on the link and prepare for
communication with the devices.

Getting status and setting options by RDM

The status and options listed in the table below can be read and set by RDM.
You can set an option on one fixture by sending a unicast RDM command to
that one fixture only, or you can set the same option on all the fixtures on the
data link by sending a broadcast RDM command to all the devices on the link.
For status reading, you can only use unicast RDM to read information from an
individual fixture.

RDM functions

As a minimum, MH 10 supports the following RDM functions:
Device discovery
DISC_UNIQUE_BRANCH
DISC_MUTE
DISC_UN_MUTE
Device management
DEVICE_INFO
IDENTIFY_DEVICE
DMX_START_ADDRESS
SOFTWARE_VERSION_LABEL
SUPPORTED_PARAMETERS
RESET_DEVICE
26 RUSH™ MH10 Beam FX User Manual
GET SET

 
 


